Archives


Rate this Article: (0) Votes

Review Article

Year : 2018 | Volume: 2 | Issue: 3 | Pages: 13-19

Design and Fabrication of Water Pressure Nozzle by Using CFD Flow Analysis

P Praveen Kumar1*, N.Nikhil, D.Srinivas, P Srikanth Reddy, B Krishna Teja2

doi:10.24951/sreyasijst.org/2018031003

Corresponding author

P Praveen Kumar*

Department of Mechanical Engineering, Sreyas Institute of Engineering and Technology, Hyderabad, India

  • 1. Department of Mechanical Engineering, Sreyas Institute of Engineering and Technology, Hyderabad, India
  • 2. Department of Mechanical Engineering, Sreyas Institute of Engineering and Technology, Hyderabad, India.

Received on: 1/6/2019

Revised on: 1/6/2019

Accepted on: 1/6/2019

Published on: 1/6/2019

  • Design and Fabrication of Water Pressure Nozzle by Using CFD Flow Analysis, P Praveen Kumar, N.Nikhil, D.Srinivas, P Srikanth Reddy, B Krishna Teja., 1/6/2019, Sreyas Journals, 2(3), 13-19, http://dx.doi.org/10.18831/sreyasijst/12018031003.

    Published on: 1/6/2019

Abstract

In this article the design of nozzle according to specifications was done. Further nozzle has been analyzed in CFD for determination of different Inlet/outlet properties. Based on the results of the CFD THE actual nozzle were fabricated by using lathe operation such as Turning, facing, Drilling, Tapering, Knurling and Threading and its is tested for determining the velocity and pressure. After the fabrication of the nozzle the flow analysis was carried out by determining the inlet & outlet parameters measured by the theoretical and practical analysis are shown to be approximately same.

Keywords

Knurling and Threading, Nozzle, ANSYS, CFD, Fluent.